Service manual

6.16.2 Two-sided Original Mode
NOTE:a) An original should stop pressed against the left scale
[A] in DF two-sided original mode.
b) The position of the original select switch does not
matter.
1. Set DIP SW101 [B] on the main control board as follows:
ON: 101--2, 4
OFF: 101--1, 3
2. Set a sheet of A3/11" x 17" paper [C] on the DF then press SW
101 [D] to feed the paper into the DF belt section.
3. When the paper stops on the exposure glass after the inversion,
open the DF slowly so that the paper does not move from the
stop position.
4. Confirm that the paper has stopped against the left scale.
[A]
[C]
[B]
[D]
FSM 8-33 FT5733/5433