Service manual

2.5 TRAY HEATER INSTALLATION (OPTION)
NOTE: The optional tray heaters keep copy paper dry. In humid
environments, copy paper may crease as it comes out of
the fusing unit. The heaters are available as service parts.
Required parts: P/N A0699500: Tray Heater Kit --115V 2 sets
P/N A0699501: Tray Heater Kit --230V 2 sets
The contents of the
kits are as follows:
Tray heater 1 piece
Tray heater bracket 1 piece
Wire saddle 1 piece
Philips pan head screw 3 pieces
Decal: High Temp. 1 piece
CAUTION: Unplug the copier power cord before starting the
following procedure.
1. Open the copier front door.
2. Pull out the duplex tray [A] and remove the tray stopper brackets
[B], [C] on both side rails as shown (1 screw each), and then
remove the duplex tray from the copier [duplex machines only].
3. Pull out the paper tray [D] and remove the tray stopper brackets
[E], [F] on both sides as shown (1 screw each) and then remove
the paper tray from the copier [both paper trays for non-duplex
machines].
[D]
[E]
[F]
[B]
[A]
[C]
FT5733/5433 3-22 FSM