Service manual

4. Remove the rear cover (remove 2 screws and loosen 2 screws).
5. Swing out the dc power supply board assembly [A] (1 screw).
6. Remove the main transformer assembly [B] (2 screws and 2
connectors).
7. Fix the tray heater [C] on the tray heater bracket [D] (2 screws),
and set the wire saddle [E] and the heater harness [F] on the
bracket as shown. Make 2 sets of this assembly.
[Upper tray heater]
8. Pass the heater harness through the upper heater access hole
[G] and install the tray heater assembly as shown (1 screw at the
front).
9. Connect the heater connector [H] with the copier as shown (2P
red).
[A]
[B]
[E]
[F]
[C]
[D]
[H]
[G]
FSM 3-23 FT5733/5433