Service manual

[Lower tray heater]
10. Pass the heater harness [A] through the lower heater access hole
[B] and install the tray heater assembly as shown (1 screw at the
front).
11. Connect the heater connector [C] with the copier as shown (2P
red).
[Upper and Lower tray heaters]
12. Stick the warning high temp. decal [D] on the plate, to the right of
the tray heater bracket as shown.
13. Reassemble the copier.
14. Tell the customer that the copier main switch should be turned off
and the power cord should not be unplugged at night. Otherwise,
the tray heaters will not function.
[A]
[D]
[C]
[B]
FT5733/5433 3-24 FSM