Service manual

2.7.2 Installation Procedure

NOTE: The sorter adapter is required to transport copy papers from

the copier exit rollers to the sorter entrance guide plates. It is

required when the mini-sorter (A423), midi-sorter (A411), or

sorter stapler (A366) is installed.

CAUTION: unplug the copier power cord before starting the

following procedure.

1. Remove the copier rear cover [A] (remove 2 screws and loosen 2

screws) and the left small cover [B] (2 screws).

2. Open the front door and pull out the 1st and 2nd (or the paper

and duplex) trays.

3. Remove the left and front side screws [C] of the front upper cover

[D] and remove the left cover [E] (5 screws).

4. Remove the cover plate [F] from the left cover by cutting it with

cutting pliers.

5. Install the cover bracket [G] on the rear side frame as shown (1

screw).

[F]

[E]

[B]

[D]

[A]

[C]

[G]

FT5733/5433 3-28 FSM