Service manual

6. Remove the 2 corners [A] of the left bottom cover [B] as shown
with the cutting pliers.
7. Install the sorter adapter [C] (4 screws) on the paper exit section
of the copier.
NOTE: • The front upper right part of the sorter adapter bracket
[D] should be placed in-between the copier front side
plate and the upper exit cover.
• The top and the bottom screw holes of the rear bracket
should be used for securing the sorter adapter.
8. Swing out the dc power supply board assembly [E] (1 screw).
9. Install the gear assembly [F] (3 screws) on the copier rear side
plate as shown.
NOTE: The positioning hole of the gear assembly bracket [G]
should fit over the positioning stud of the copier drive gear.
Also, the positioning pin of the gear assembly [H] should
be placed in the positioning hole of the sorter adapter
bracket.
10. Reinstall the dc power supply board.
[D]
[A]
[B]
[C]
[H]
[F]
[E]
[G]
FSM 3-29 FT5733/5433