Service manual

1.10PAPER FEED
1. Do not touch the pick-up, feed, separation rollers and the friction
pads with oily bare hands.
2. The side fences and the rear fence of the paper trays should be
positioned correctly to align with the actual paper size.
Otherwise, paper misfeeds may occur.
3. The friction pad should be replaced together with the friction pad
holder and pad entrance seal as an assembly.
4. The friction pad assembly and the paper feed roller should be
replaced as a set to maintain paper feed ability. (A worn out feed
roller will provide incorrect friction pad pressure.)
5. The friction pad holder mounting bracket must be reinstalled on
the original paper tray. Because the friction pad pressure is
adjusted for each paper feed station independently at the factory.
6. The paper tray with the friction pad mechanism must be
reinstalled at the original paper feeding station.
7. The friction pad pressure should not be adjusted in the field.
1.11FUSING UNIT
1. Be careful not to damage the edges of the hot roller strippers or
their tension springs.
2. Do not touch the fusing lamp with bare hands.
3. Make sure that the fusing lamp is positioned correctly and that it
does not touch the inner surface of the hot roller.
FT5733/5433 4-6 FSM