Service manual

Smart Organizing Monitor (Printer Model)
G165/G166/G167/G181/G183/G184 5-34 SM
Item Selections Remarks
Horizontal (-15 to +15)
step
1.32mm per step. Range is -5mm to
+5mm.
If the machine settings are reset to
the factory defaults, this value does
not change.
The printer will exit the energy saver
state after this setting is changed.
Duplex Tray
Vertical (-15 to +15) step
0.24mm per step. Range is -3.6mm
to +3.6mm
If the machine settings are reset to
the factory defaults, this value does
not change.
The printer will exit the energy saver
state after this setting is changed.
Fuser SC Reset
This button is for resetting an SC
related with the fusing errors.
Fuser SC Detect On/Off
If On, the engine detects SC559. If
Off, the engine does not detect
"Fusing SC Reset.”
Reset Transfer Unit
Life Counter
Resets the transfer unit life counter.
Trans. Belt Adjust
When you click the [Trans. Belt
Adjust] button, the transfer belt
adjustment is done. This calibrates
the motor speed to match the length
of the new transfer belt.
"*" indicates the factory default value.
CÓPIA NÃO CONTROLADA
CÓPIA NÃO CONTROLADA