Service manual

Laser Optics
SM 3-11 G165/G166/G167/G181/G183/G184
Replacement
Adjustment
After replacing the laser optics housing unit
Before performing this procedure, please refer to Technical Service Bulletin –
G165/G166/G167/G181/G183/G184 – 026 Laser Optics Housing Replacement.
 Do the following step 2 with the front cover of the machine open.
1. Open the front cover and turn on the machine.
2. Input the setting values for the laser optics housing unit.
 Printer model: "LSU Adjustment" in the "SP Mode 2" tab
 MF model: "LSU Adjustment" in the "Engine Maintenance" menu (MF model).
The settings are on a sheet of paper that comes with the laser optics housing unit.
3. Close the front cover.
4. Execute "Color Registration" in the "SP Mode 2" tab (printer model) or the "Engine
Maintenance" menu (MF model).
5. Adjust the registration settings for each tray and for the front and rear sides of the
paper with the "SP Mode 2" tab (printer model) or the "Engine Maintenance" menu (MF
model) if necessary.
⇒
Rev. 08/24/2009
CÓPIA NÃO CONTROLADA
CÓPIA NÃO CONTROLADA