User's Manual

Table Of Contents
Item Description
I/O timeout
(Network)
Select whether or not to apply a timeout limit if the machine takes longer than a
specified time to process a job.
Ethernet Speed Ethernet communication speed. For normal use, select Auto Select. This allows
the device to select the optimum speed.
If communication with the device fails, select 10Mbps Full Duplex, 10Mbps
Half Duplex, 100Mbps Full Duplex, or 100Mbps Half Duplex.
Configuring the IPv4 settings
Click [IPv4] to display the page for configuring the IPv4 settings.
IPv4
Item Description
IPv4 Indicates that IPv4 is enabled.
Ethernet
Item Description
Host Name Enter the host name you want to set for the network interface board, using up to
63 characters. The default is RNP, followed by the MAC address of the active
interface board. If you change the name to other than the default, the new name
cannot begin with "RNP" or "rnp".
DHCP Select [Enable] to automatically configure the network settings using the DHCP
server. Select [Disable] to manually configure the network settings.
8. Configuring the Machine Using Utilities
132