User's Manual
Table Of Contents
- Operating Instructions
- TABLE OF CONTENTS
- How to Read This Manual
- Model-Specific Information
- Important Safety Instructions
- Important Safety Instructions
- ENERGY STAR Program
- 1. Guide to the Machine
- 2. Loading Paper
- 3. Printing Documents
- 4. Copying Originals
- 5. Scanning Originals
- 6. Sending and Receiving a Fax
- Fax Mode Screen
- Setting the Date and Time
- Entering Characters
- Registering Fax Destinations
- Sending a Fax
- Using the Fax Function from a Computer (PC FAX)
- Receiving a Fax
- Lists/Reports Related to Fax
- 7. Configuring the Machine Using the Control Panel
- 8. Configuring the Machine Using Utilities
- 9. Maintaining the Machine
- 10. Troubleshooting
- 11. Appendix
- INDEX
Configuring Network Settings
This section describes configuring the settings required to use the machine on a network.
Configuring the IP Address Settings Using the Control Panel
The procedure for configuring network settings differs depending on whether IP address information is
assigned automatically by the network (DHCP), or manually.
The IP address can also be configured via Web Image Monitor. For details about configuring the IP
address, see page 127 "Using Web Image Monitor".
Setting the machine to receive an IPv6 address automatically
• A DHCP server is required on the network for the machine to receive an IPv6 address
automatically.
• Make sure [DHCPv6] is set to [Enable] in [IPv6] in Web Image Monitor. For information about how
to launch Web Image Monitor, see page page 127 "Using Web Image Monitor".
1. Press the [User Tools] key.
2. Press the [
] or [ ] key to select [Network Settings], and then press the [OK] key.
3. Press the [ ] or [ ] key to select [Machine IPv6 Address], and then press the [OK] key.
4. Press the [ ] or [ ] key to select [Use IPv6], and then press the [OK] key.
5. Press the [ ] or [ ] key to select [On], and then press the [OK] key.
After a setting has been changed, the machine automatically reboots itself.
Assigning the machine's IPv6 address manually
• The IPv6 address assigned to the machine must not be used by any other device on the same
network.
• Make sure [DHCPv6] is set to [Disable] in [IPv6] in Web Image Monitor. For information about
how to launch Web Image Monitor, see page page 127 "Using Web Image Monitor".
Configuring Network Settings
21