User's Manual

Message Causes Solutions
Print Cart. Set Error The print cartridge has not been
installed or has not been
installed correctly.
Reinstall the print cartridge. See page 253
"Replacing the Print Cartridge".
Remove Paper:
Bypass Tray
The machine failed to proceed
with the print job, because tray
1 was specified as the input tray
but paper was set in the bypass
tray.
Remove paper from the bypass tray.
Replace Required
Soon:
Print Cartridge
The print cartridge is almost
empty.
Prepare a new print cartridge.
Replacement
Required:
Fusing Unit
The fusing unit is no longer
usable, and must be replaced.
Contact your sales or service
representative.
Replacement
Required:
Paper Feed Roller
The paper feed roller is no
longer usable, and must be
replaced.
Contact your sales or service
representative.
Replacement
Required:
Print Cartridge
The machine has run out of
toner.
Replace the print cartridge. See page 253
"Replacing the Print Cartridge".
Replacement
Required:
Transfer Roller
The transfer roller is no longer
usable, and must be replaced.
Contact your sales or service
representative.
RX Comm. Error A reception error occurred, and
the fax could not be received
correctly.
If possible, contact the sender of the fax
and ask them to resend it.
Scan (NW)
Disconnected
A scanned file could not be sent
because the Ethernet cable was
not connected properly.
Reconnect the Ethernet cable properly,
and then try the operation again.
Scan (USB)
Disconnected
The USB cable was
disconnected while scanning
from a computer.
Reconnect the USB cable properly, and
then try the operation again.
10. Troubleshooting
266 opal-p3_mf3_com_user_guide_gb_00228530_eng.xml
Draft 2016/05/27