User's Manual
Table Of Contents
- Operating Instructions
- TABLE OF CONTENTS
- How to Read This Manual
- Model-Specific Information
- Important Safety Instructions
- Important Safety Instructions
- ENERGY STAR Program
- 1. Guide to the Machine
- 2. Loading Paper
- 3. Printing Documents
- 4. Copying Originals
- 5. Scanning Originals
- 6. Sending and Receiving a Fax
- Fax Mode Screen
- Setting the Date and Time
- Entering Characters
- Registering Fax Destinations
- Sending a Fax
- Using the Fax Function from a Computer (LAN-Fax)
- Receiving a Fax
- Lists/Reports Related to Fax
- 7. Configuring the Machine Using the Control Panel
- 8. Configuring the Machine Using Utilities
- 9. Maintaining the Machine
- 10. Troubleshooting
- 11. Appendix
- INDEX
• Stateless Address 2
•
Stateless Address 3
• Stateless Address 4
• Link-local Address
Displays the IPv6 link local address.
• Contact your network administrator for information about the network configuration.
Wireless LAN Setup (Type 2 model only)
This section describes how to configure the wireless LAN settings manually using the control panel. For
easy setup using WPS (Wi-Fi Protected Setup), see Wi-Fi Settings Guide.
• If [Disable] is specified for the [Wi-Fi Enable] setting, you cannot use the [Setup Wizard]. Specify
[Enable] for the [Wi-Fi Enable] setting first. If you change the [Wi-Fi Enable] setting, the machine
must be restarted.
•
Ensure that the router, access point, or device equipped with a wireless LAN, etc., is turned on.
• Also, check the authentication method and the name of the router, access point, or device
equipped with a wireless LAN (SSID/IBSS) in advance.
Infrastructure mode
Use the following procedure to connect to the wireless LAN router or access point manually.
1. Press the [User Tools] key.
2. Press the [ ] or [ ] key to select [Network Settings], and then press the [OK] key.
If you are requested to enter a password, enter the password using the number keys, and then
press the [OK] key.
3. Press the [ ] or [ ] key to select [Wi-Fi], and then press the [OK] key.
4. Press the [ ] or [ ] key to select [Setup Wizard], and then press the [OK] key.
5. Press the [ ] or [ ] key to select [Infrastructure], and then press the [Next] key.
6. Press the [ ] or [ ] key to select the destination SSID, and then press the [Next] key.
If you cannot find the destination SSID, check that the device is turned on.
When entering the SSID, select [SSID], and then press the [Next] key.
The SSID entry screen appears. Enter the SSID using the number keys, and then press the [Next]
key.
7. Configuring the Machine Using the Control Panel
162