User's Manual

Copying Both Sides of an ID Card onto One

Side of Paper

This section describes how to copy the front and back sides of an ID card, or other small document, onto

one side of a sheet of paper.

When copying onto A4 size paper, you can copy documents that are smaller than A5 size. Likewise,

when copying onto a Letter size paper, you can copy documents that are smaller than Half Letter size.

• This function is only available when the original is set on the exposure glass, not when it is set in the

ARDF or ADF.

• To use this function, the paper size used for printing copies must be set to A4 or Letter.

• To use the [Short Cut] key to set ID card copy mode for the current job, [Short Cut Key Setting]

under administrator settings must be set to [ID Card copy mode].

CES165

To use this function, first switch to ID card copy mode for the current job, and then perform ID card copy.

1. Press the [Short Cut] key.

CES201

The machine is now in ID card copy mode. Proceed to the following steps to perform the ID card

copy.

2. Place the original front side down and top to the machine rear on the exposure glass.

Place the original in the center of the A5/Half Letter scan area.

4. Using the Copier Function

166 rinmei-mf2_com_user_guide_gb_00063310_eng.xml

操作部イラストは現状

PerMF3のままです

No.102【ショートカットキーがID-CardCopyMode以外】

ShortCutの設定がIDCardCopyの場合、ShortCut押下で一時的

にIDCardCopyモードに遷移すること確認しました。

ただし、ShortCutの割り当てが別の機能の場合、IDCardCopyを

一時設定する方法が不明です。コピー初期設定配下の拡大縮小で

IDCardを設定する（初期値を変更する）以外の方法はないのでし

ょうか？

Draft 2011/08/29