User's Manual

CMF065

3. Press the [Start] key.

A message prompting you to place the original back side down on the exposure glass appears on

the display.

4. Within 30 seconds, place the original back side down and top to the machine rear on the

exposure glass, and then press the [Start] key again.

• You can press the [Escape] key to exit to the previous level of the menu tree.

• Regardless of the machine's reduction or enlargement ratio setting, an ID card copy will always be

made at 100%.

• You can change the machine's default [Reduce/Enlarge] setting to always make photocopies in ID

card copy mode. In addition, if the [Short Cut] key is not set to [ID Card copy mode], you must

configure the machine's default setting to perform ID card copy.

• Setting this function for the current job temporarily disables 2-sided copying automatically.

However, after the temporary job setting is cleared, the 2-sided copying will be enabled again

automatically.

• Temporary job settings are cleared in the following cases:

• When no input is received for the period of time specified in [System Auto Reset Timer] while

the initial screen is displayed.

• When the [Clear/Stop] key is pressed while the initial screen is displayed.

• When the machine's mode is changed.

• When the power is turned off.

• When the machine's default for the same setting is changed.

• For details about [Short Cut Key Setting], see p.301 "Administrator Settings".

• For details about [Reduce/Enlarge], see p.259 "Copy Settings".

• For details about [System Auto Reset Timer], see p.301 "Administrator Settings".

Copying Both Sides of an ID Card onto One Side of Paper

rinmei-mf2_com_user_guide_gb_00063310_eng.xml 167

削除

Usethesamemode(colororblack-and-white)forbothsides.

Draft 2011/08/29