User's Manual

Scanning Using the Control Panel

Scanning using the control panel allows you to send scanned files via e-mail (Scan to E-mail), to an FTP

server (Scan to FTP), or to the shared folder of a computer on a network (Scan to Folder), or to a USB

flash disk (Scan to USB).

The Scan to E-mail, Scan to FTP, and Scan to Folder functions are available only through a network

connection. No network connection is required for the Scan to USB function; you can send scanned files

directly to a USB flash disk inserted into the front of the machine.

Basic Operation for Scan to E-mail/FTP/Folder

This section describes the basic operation for sending scanned files via E-mail, to an FTP server, or to a

computer. The scanned file is sent via E-mail, to an FTP server, or a computer, depending on the

specified destination.

• The original in the ARDF or ADF takes precedence over the original on the exposure glass if you

place originals both in the ARDF/ADF and on the exposure glass.

• When using the Scan to E-mail, Scan to FTP or Scan to Folder function, you must first register the

destination in the Address Book using Web Image Monitor.

• If a USB flash disk is inserted in the machine, scanning functions other than Scan to USB are not

possible from the control panel. Make sure there is no USB flash disk inserted in the machine.

1. Place the original on the exposure glass or in the ARDF/ADF.

2. Press the [Scanner] key, and then press the [Address Book] key.

CES180

Alternatively, you can press the [Short Cut] key if [Short Cut Key Setting] under administrator

settings is set to [Scan to Address].

Scanning Using the Control Panel

rinmei-mf2_com_user_guide_gb_00059731_eng.xml 183

操作部イラストは現状

PerMF3のままです

ShortCutキーでは手順3まで実行した状態に遷

移するとの事ですので、次回修正します。

Draft 2011/08/29