User's Manual

Removing Printing Jams
If a paper jam occurs, one of the following messages appears on the screen:
• "Misfeed: Paper Tray"
• "Misfeed: Dup. Unit Remove Paper"
• "Internal Misfeed"
• "Misfeed: Stnd. Tray"
• "Misfeed: Tray 1"
• "Misfeed: Tray 2
• Jammed paper may be covered in toner. Be careful not to get toner on your hands or clothes.
• Toner on prints made immediately after clearing a paper jam may be insufficiently fused and can
smudge. Make test prints until smudges no longer appear.
• Do not forcefully remove jammed paper, as it may tear. Torn pieces remaining inside the machine
will cause further jams and possibly damage the machine.
• Paper jams can cause pages to be lost. Check your print job for missing pages and reprint any
pages that did not print out.
Removing internal/tray 1/tray 2 jam
If "Internal Misfeed", "Misfeed: Tray 1", "Misfeed: Tray 2" appears on the display, follow the procedure
below to remove it.
• The inside of this machine becomes very hot. Do not touch the parts labeled "
" (indicating a
hot surface).
• Some of this machine's internal components get very hot. For this reason, take care when
removing misfed paper. Not doing so could result in burns.
9. Troubleshooting
368 rinmei-mf2_com_user_guide_gb_00059883_eng.xml
9
No.70【ジャムメッセージ】
印刷時のジャム発生時のメッセージについてご教示ください。
RinMF1のマニュアルでは以下を記載していて、MF2のメッセージとの対応は以下の通りと考えていま
す。
•BypassTrayPaperMisfeedJam→？
•DuplexJamDuplexMisfeedJam→Misfeed:Dup.UnitRemovePaper
•InnerJam→InternalMisfeed
•LowerMisfeedJam→Misfeed:Tray2
•OuterJam→Misfeed:Stnd.Tray
•UpperMisfeedJam→Misfeed:Tray1
①『Pro2StatusListSpecV1.0220110803』を見ても"BypassTray・・・"のメッセージに対応するメ
ッセージと思えるものが見当たりません。ただし、"Misfeed:PaperTray"というメッセージがあるよう
なので、これが"BypassTray・・・"に対応するメッセージでしょうか？
②"Misfeed:PaperTray"発生時の対処は、MF1で"BypassTray・・・"が発生した時の対処と思って良
いでしょうか？
Draft 2011/08/29