User's Manual

Message Causes Solutions
Failed to Create File
Press Clear key
The Scan to USB function failed
because there was not enough
memory on the USB flash disk.
Use a USB flash disk with enough memory.
Fax Job Memory
Overflow
The number of fax jobs in
memory (unsent or unprinted
faxes) has reached maximum,
so new jobs cannot be stored.
Wait until pending jobs have been
transmitted or printed.
I-Fax POP3 fails
Connection to the POP3 server
failed.
• Confirm that the network cable is
properly connected to the machine.
• Confirm that the network settings such
as IP address, DNS, and POP3
settings have been configured
properly (make sure that no double-
byte character is used). See p.334
"Configuring the Network Settings".
I/O Timeout
The timeout period set in [I/O
Timeout] expires when printing
is frequently interrupted by data
from other ports, or when
printing data is large and takes
time for processing.
If [I/O Timeout] is set to 15 seconds,
increase the time period. For details, see
p.281 "System Settings".
Indep.Sply.Toner:
Black
A non-supported print cartridge
is installed.
Remove and replace it with a print
cartridge specified by an authorized
dealer.
Internal Misfeed
Paper has been jammed in the
machine.
Remove the jammed paper. See p.368
"Removing Printing Jams".
Memory Full
The machine's memory reached
capacity while storing a fax in
memory in Memory
Transmission mode.
Resend the fax in parts as several at a
lower resolution.
Memory Almost Full
Memory has almost reached
capacity during sort copy.
If several originals are still to be scanned,
it is recommended to start printing now,
and copy the remaining originals
separately. If originals are being scanned
from the ARDF or ADF, remove any
remaining pages from the ARDF or ADF.
Error and Status Messages on the Screen
rinmei-mf2_com_user_guide_gb_00059899_eng.xml 405
9
削除forthe
indicatedcolor.
MemoryOverflowに変更します
Draft 2011/08/29