User's Manual

Select this to adjust the duplex back side registration vertically.
Scan warming up time
If the machine is used in a room where the temperature is low, the machine may not be able to
scan originals clearly. Selecting [Longer] for this setting may improve the scanning quality.
Default: [Normal]
• Normal
Select this if the room temperature is about 19 °C (66.2 °F) or higher.
• Longer
Select this if the room temperature is about 18 °C (64.4 °F) or lower. This prolongs the warm-
up time for the machine's scanning unit by about 10 seconds.
Low humidity
If the machine is used in a room where humidity level is low, black lines of a few millimeters thick
may appear on printouts with 75-millimeter spaces in between. Selecting [On] for this setting may
prevent these lines from appearing.
Note that when this setting is enabled, the machine automatically performs self-maintenance in
every 15 minutes.
Default: [Off]
• On
• Off
Auto Cleaning
Sets the machine to execute periodic cleaning of the interior. You may hear some noise while
cleaning is being executed. This noise does not indicate a malfunction.
Default: [On]
• On
• Off
Image Density
TBD
Default: 2
• -3 to +3
7. Configuring the Machine Using the Control Panel
288 rinmei-mf2_com_user_guide_gb_00059818_eng.xml
7
No.67【SystemSettings-TBCleaning,ImageDensity】
『PRO2MFLCDPanelOperationSpecV1.02@20110803』「2.2.11TB
CleaningMenu」「2.2.12ImageDensityMenu」
①TBCleaningが追加されていますが（MF2のみ）、PerMF3と同様の機
能でしょうか。
②ImageDensityはMF2とP2の両方に追加されていますが、この機能の
内容が分かりません。恐れ入りますがご教示頂けますと助かります。
③FWv0.24で実機確認したところ、いずれのメニューも実装されていない
ようでした。これは現時点の実装の問題でしょうか。
Draft 2011/08/29