Operation Manual

Message Causes Solutions
"Updating the destination
list... Please wait. Specified
destination(s) or sender's
name has been cleared."
The destination list is being
updated from the network
using Web Image Monitor.
Wait until the message disappears. Do
not turn off the main power switch
while this message is displayed.
Depending on the number of
destinations to be updated, there may
be some delay before you can resume
operation. Operations are not possible
while this message is displayed.
"You do not have the
privileges to use this
function."
The logged in user name
does not have permission for
the selected function.
For details about how to set
permissions, see Security Guide .
"Exceeded max. data
capacity. Check the
resolution and the ratio and
then press the Start key
again."
The data being scanned is
too large for the scale ratio
specified in [Specify Size].
Reduce the resolution or [Specify Size]
value, and then try to scan the original
again.
"The size of the scanned
data is too small. Check the
scanning resolution, then
press the Start key again."
The data being scanned is
too small for the scale ratio
specified in [Specify Size].
Specify a higher resolution or a large
size in [Specify Size], and then try to
scan the original again.
"Not all of the image will be
scanned."
If the scaling factor specified
in "Reproduction Ratio" is
too large, part of the image
may be lost.
• Reduce the scaling factor in
"Reproduction Ratio", and then try
to scan the original again.
• If displaying the entire image is
not necessary, press the [Start]
key to start scanning with the
current scaling factor.
"Not all of the image will be
scanned."
Using "Reproduction Ratio"
to scale down a large
document may cause part of
the image to be lost.
• Specify a large size in [Specify
Size], and then try to scan the
original again.
• If displaying the entire image is
not necessary, press the [Start]
key to start scanning with the
current scaling factor.
10. Troubleshooting
208