Operation Manual

Message Causes Solutions
"Hardware Problem: Wireless
Card"
(A "wireless LAN board" or
"Bluetooth interface unit" is
referred to as a "wireless card".)
The wireless LAN board can
be accessed, but an error was
detected.
Turn off the main power switch,
and then confirm the wireless
LAN board is inserted correctly.
And then, turn on the main power
switch again. If the message
appears again, contact your
service representative.
"Hardware Problem: Wireless
Card"
(A "wireless LAN board" or
"Bluetooth interface unit" is
referred to as a "wireless card".)
• The Bluetooth interface
unit was connected while
the machine was turned
on.
•
The Bluetooth interface
unit was removed while
the machine was turned
on.
Turn off the main power switch,
and then confirm the Bluetooth
interface unit is inserted correctly.
And then, turn on the main power
switch again. If the message
appears again, contact your
service representative.
"Out of paper in n. Load paper
of the following size and type.
To cancel the current job, press
[Job Reset]."
(A figure is placed at n.)
The printer driver settings are
incorrect or the tray does not
contain paper of the size
selected in the printer driver.
Check that the printer driver
settings are correct, and then
load paper of the size selected in
the printer driver into the tray. For
details about how to change the
paper size, see "Changing the
Paper Size", Paper Specifications
and Adding Paper .
When Messages Are Displayed on the Control Panel
183