Operation Manual

DHJ353
• If you cut off the paper edges of a paper roll that is installed in the paper input location, be careful
not to cut the cloth part of the output basket.
• When removing paper rolls from the paper input locations, lift the flanges on either side of the
paper roll before removing them. Do not lift one side only. This could damage the machine.
DNE035
• Do not squeeze the flange into the paper roll when the end face of the paper roll is not aligned to
the paper core or when a small quantity of paper is left. If the flange is squeezed too tightly against
the paper roll, the edge of the paper may crease or wrinkle.
• To cut paper edges with scissors, cut the paper vertically to the feed direction, so that the paper
edges can be pulled into the machine.
Load the paper roll when the power of the machine is on.
Check that the output basket is in basic mode before loading a paper roll. For details, see page 31
"Setting Up the Output Basket in Basic Mode".
The paper roll is heavy and may need to be lifted by two people.
When replacing paper holder to other paper roll, place the paper roll on a flat surface.
Loading Paper
141