Operation Manual

• Adjustment results vary depending on the Prevent Paper Abrasion mode's status. If you perform an
adjustment while Prevent Paper Abrasion mode is enabled and do not want to print using this
mode, cancel Prevent Paper Abrasion mode, and then perform the adjustment again.
• Perform no other operations while the test sheet is printing.
• An error will occur and test sheets will not print if:
• There is a misfeed.
• One of the machine's covers is open.
• The machine is performing maintenance operations.
• The machine has run out of ink.
• The machine has run out of paper.
1. Press [Home] ( ) at the bottom of the screen in the center.
2. Flick the screen to the left, and then press the [User Tools] icon ( ).
3. Press [Machine Features].
4. Press [Maintenance].
5. Press [Adjust Print Position].
6. Select the paper input location of the print position you want to adjust, and then press
[Print Test Sheet].
7. Press [Start Printing].
8. Check the optimal adjustment value based on the print results of the test sheet.
• Measure the margins between the center of the printed lines and the paper edges.
Adjusting the Print Quality
237