Operation Manual

123
5. Using On-Screen Menu
ALERT MAIL
ALERT MAIL This option will notify your computer of lamp replace time or error
messages via e-mail when using wireless or wired LAN.
Placing a checkmark will turn on the Alert Mail feature.
Clearing a checkmark will turn off the Alert Mail feature.
Sample of a message to be sent from the projector:
The lamp and filters are at the end of its usable life. Please replace
the lamp and filters.
Projector Name: rdpj
Lamp Hours Used: 100 [H]
—
HOST NAME Type in a host name. Up to 15 alphanumeric
characters
DOMAIN NAME Type in a domain name of the network connected to the projector. Up to 60 alphanumeric
characters
SENDER'S ADDRESS Specify the sender’s address. Up to 60 alphanumeric
characters and symbols
SMTP SERVER NAME Type in the SMTP server name to be connected to the projector. Up to 60 alphanumeric
characters
RECIPIENT'S ADDRESS
1, 2, 3
Type in your recipient’s address. Up to 60 alphanumeric
characters and symbols
TEST MAIL
Send a test mail to check if your settings are correct.
NOTE:
• If you entered an incorrect address in a test, you may not receive an Alert mail. Should this
happen, check if the Recipient’s Address is correctly set.
• Unless any one of the [SENDER'S ADDRESS], [SMTP SERVER'S NAME] or [RECIPIENT'S ADDRESS
1-3] is selected, [TEST MAIL] is not available.
• Be sure to highlight [OK] and press the ENTER button before executing [TEST MAIL].
—