Operation Manual

7
1. Introduction
❸ Part Names of the Projector
Front/Top
The lens is sold separately. The description below is for when the Standard Lens Type1 lens is mounted.
Controls
(→ page 9)
Lens Shift Dial (vertical/horizontal)
(→ page 21)
Lens
Remote Sensor (located on the front
and the rear)
(→ page 13)
Remote Sensor
(→ page 13)
Zoom Lever/Zoom Ring (→ page 25)
Lens Cap
(The optional lens is shipped with the
lens cap.)
Focus Ring
(→ page 22)
Adjustable Tilt Foot
(→ page 25)
Indicator Section
(→ page 9)
Securing lever cover
(→ page 164)
Lens Release Button
(→ page 154)
Adjustable Tilt Foot
(→ page 25)
Exhaust vent
Heated air is exhausted from here.
Mounting the strap
1. Mount the strap to the filter cover and lamp cover as shown on the diagram below.
2. Insert the knot in the strap into the hole on the bottom of the projector and pull in the direction of the arrow to fasten.
ab
How to paste the input selection character sticker of the remote control
• Peel off the cover of the sticker and align the sticker holes with Buttons 1 to 6 before pasting.
• Please take care not to let the sticker contact the buttons when pasting.
• The explanations and illustrations in this manual are provided with the sticker pasted.
Ethernet
Ethernet
Ethernet
Lamp Cover (→ page 176)
Security Bar
Attach an anti-theft device.
The security bar accepts security wires
or chains up to 0.18 inch/4.6 mm in
diameter.
Monaural Speaker (10 W)