Operation Manual

10
1. Introduction
Terminals
23112
8
9
10
11
7
4
5151613 14 6
1. HDMI 1 IN Connector (Type A)
(→ page 156, 158, 162)
2. HDMI 2 IN Connector (Type A)
(→ page 156, 158, 162)
3. DisplayPort IN Connector
(→ page 156)
4. BNC IN [R/Cr/CV, G/Y/Y, B/Cb/C, H, V] Connectors (BNC
× 5)
(→ page 155, 160)
5. BNC (CV) Input Connector (BNC × 1)
(→ page 160)
6. BNC (Y/C) Input Connector (BNC × 2)
(→ page 160)
7. BNC AUDIO IN Mini Jack (Stereo Mini)
(→ page 158, 160)
8. COMPUTER IN/ Component Input Connector (Mini
D-Sub 15 Pin)
(→ page 155, 161)
9. COMPUTER AUDIO IN Mini Jack (Stereo Mini)
(→ page 155, 161)
10. Ethernet Port (RJ-45)
(→ page 166)
11. USB-A Port (Type A)
(→ page 211)
12. HDMI OUT Connector (Type A)
(→ page 159)
13. AUDIO OUT Mini Jack (Stereo Mini)
(→ page 159)
14. 3D SYNC Connector (Mini DIN 4 Pin)
(→ page 39)
15. PC CONTROL Port (D-Sub 9 Pin)
(→ page 244)
Use this port to connect a PC or control system. This enables
you to control the projector using serial communication
protocol. If you are writing your own program, typical PC
control codes are on page 250.
16. REMOTE Connector (Stereo Mini)
This port is for the dealer or service personnel. For details,
contact your dealer.
NOTE:
• When a remote control cable is connected to the REMOTE connector, infrared
remote control operations cannot be performed.