Operation Manual
62
Pin
• PIN Protect: The PIN (personal identication number) feature allows you to
password protect your projector. Once you enable the PIN feature, you must
enter the PIN before you can project an image. (PIN Default : 12345)
• Change PIN: This item allows you to change the PIN.
Communications
• LAN:
- DHCP: Turn the DHCP ON/OFF.
- IP Address: Assign Network IP Address.
- Subnet Mask: Assign Network Subnet Mask.
- Default Gateway: Assign Network Default Gateway.
- MAC Address: Display the network MAC Address value.
- Apply: Apply Network settings.
• Network:
- Projector Name: Display the projector hostname for Network.
- Restart Network: Restart the network.
- Network Factory Reset: Perform factory reset on the network settings. The
Projector Name, LAN IP, and SNMP settings will be reset.
• Serial Port Baud Rate: Select the serial port and baud rate.
• Serial Port Path: Select the serial port path from either RS232 or HDBaseT
Port.
• Projector Address: Set the projector address. The projector will respond to IR
remotes set either at the same address as the projector or to IR remotes set to
address 0.