Operation Manual

64
Test Pattern
Choose the desired internal test pattern to display, or select Off to turn off a test
pattern.
Background Color
Use this feature to display a “Logo”, “Blue”, “Black” or “White” screen when no
signal is available.
Hot-Key settings
Assign a different function to the hot-key on the remote control by highlighting the
function in the list and pressing ENTER. Choose a function that does not already
have a dedicated button, and assign the hot-key to that function, allowing you to
quickly and easily use the chosen function.
Power Settings
• Standby Power Mode:
- 0.5W mode: The projector is in standby mode when connected to AC power.
(<0.5W)
- Communication mode: The projector could be controlled via the LAN terminal
during power standby.
• Direct Power On: The projector automatically turns on when electrical power is
connected.
• Auto Power Off: Automatically turns the projector off after no signals are de-
tected for a preset number of minutes. If an active signal is received before the
projector powers down, the image will be displayed.
• Sleep Timer: This item allows the projector to automatically power off after it
has been on for a specied amount of time.
Light Source Settings
• Light Source Mode: Select Constant Power, Constant Luminance or Eco Mode.
When in Eco Mode, the projector will adjust to the lowest fan speed and switch
the laser diode power to the minimum setting.
• Constant Power Settings: Set the value of the laser diode power (in Watts).
• Constant Luminance Settings: Set the value for the Constant Luminance Set-
tings to maintain constant brightness. The light sensor will monitor the light
level and will apply more power as the laser brightness decays naturally over
time. When the laser setting reaches maximum power of 405W, it will remain
at this setting. Note that the light sensor needs to be calibrated for Constant
Luminance mode to work properly.
• Total Projector Hours: Display current total hours the projector used.