Operation Manual

9
WARNING
 If the machine topples, or if a cover or other part gets broken, you must turn
off its power immediately. After turning off the power, be sure to disconnect
the power cord plug from the wall outlet. Then contact your service represen-
tative and report the problem. Do not use the machine. Doing so could result
in re or electric shock.
WARNING
 Contact your sales or service representative to clean or replace parts for a
projector that is installed on a wall or ceiling.
 Do not attempt to clean or replace parts for a projector that is installed in
a high location on a wall or ceiling. Doing so may cause it to fall down,
resulting in an injury.
WARNING
 If a projector is incorrectly installed on a wall or ceiling, it may fall down and
cause an injury. Contact your sales or service representative if you want to
install a projector on a wall or ceiling.
 Use brackets that are strong enough to support the projector. The projec-
tor weighs about 18kg(40lb) (Projector weight without lens).
 The projector must be installed in a location that is sturdy enough to sup-
port the full weight of the projector and brackets.
CAUTION
 The machine may be very hot after it is turned off, especially the vents and
the lower part of the unit where the laser is located. Avoid touching these
areas. Doing so may result in burns.
CAUTION
 Do not place the product on other equipment or vice versa. Doing so may
cause heat buildup inside the product or cause the other equipment to mal-
function.