User's Manual

Table Of Contents
Message Causes Solutions
Cannot Copy
Change Paper Size
The paper for combine copy,
duplex copy or ID Card copy is
not loaded.
Load the appropriate size paper.
TiO
Codes on the Screen
If "C", or "c" appears, contact your sales or service representative.
Code Causes Solutions
E0 A paper jam has occurred in the
machine.
Remove the jammed paper. See
page 144 "Paper Feed Problems".
E1 Paper has been jammed in the paper
tray.
The input tray has run out of paper.
Remove the jammed paper. See
page 144 "Paper Feed Problems".
Load paper to the input tray. See
page 36 "Loading Paper".
E3 A maintenance cover is open. Close the maintenance cover completely.
E4 Front cover is closed. Open the front cover completely.
E5 An appropriate size paper for printing
Report is not loaded.
Load the appropriate size paper.
E6 The print cartridge has not been
installed.
Reinstall the print cartridge. See page 137
"Replacing the Print Cartridge".
E7 The machine has run out of the toner. Replace the print cartridge. See page 137
"Replacing the Print Cartridge".
E8 The print cartridge is almost empty. Prepare a new print cartridge.
E9 An appropriate size paper for making
copies is not loaded.
Load the appropriate size paper.
P1 The paper size set for the document
differs from the size of the paper.
Press the [Start] key to begin printing, or press
the [Stop/Clear] key to cancel the job.
If [Auto Continue:] is set to [0 sec], no error
message appears.
10. Troubleshooting
162 meihua-p2_mf2_com_user_guide_00106454_eng.xml
Draft 2013/03/26