User's Manual

English

Notes to USA Users of FCC Requirements

Part 15 of the FCC Rules

Note

This equipment has been tested and found to comply with the limits for a

Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are

designed to provide reasonable protection against harmful interference in a

residential installation. This equipment generates, uses and can radiate radio

frequency energy and, if not installed and used in accordance with the instruc-

tions, may cause harmful interference to radio communications. However,

there is no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television recep-

tion, which can be determined by turning the equipment off and on, the user

is encouraged to try to correct the interference by one more of the following

measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to

which the receiver is connected.

Consult the dealer or an experienced radio /TV technician for help.

Caution

Changes or modifications not expressly approved by the party responsible for

compliance could void the user's authority to operate the equipment.

Part 68 of the FCC Rules

FCC Requirements

1) This equipment complies with Part 68 of the FCC rules and requirements adopted

by the ACTA. On the cover of this equipment is a label that contains, among other

information, a product identiﬁ er in the format US:AAAEQ##TXXXXX. If requested,

this number must be provided to the telephone company.

2) This equipment uses the RJ11C USOC jack.

3) A plug and jack used to connect this equipment to the premises wiring and tele-

phone network must comply with the applicable FCC Part 68 rules and require-

ments adopted by the ACTA. A compliant telephone cord and modular plug is

provided with this product. It is designed to be connected to a compatible modular

jack that is also compliant. See installation instructions for detail.

4) The REN is used to determine the number of devices that may be connected to a

telephone line. Excessive RENs on a telephone line may result in the devices not

ringing in response to an incoming call. In most but not all areas, the sum of RENs

should not exceed ﬁ ve (5.0). To be certain of the number of devices that may be

connected to a line, as determined by the total RENs, contact the local telephone

company. The REN for this product is part of the product identiﬁ er that has the

format US:AAAEQ##TXXXXX. The digits represented by ## are the REN without a

decimal point (e.g., 03 is a REN of 0.3).

❖

•

❖