User's Manual
Table Of Contents
- 6. Troubleshooting
- 7. Maintenance and Specifications
- General Requirements
- Moving the Printer
- Cleaning the Printer
- Adjusting the Color Registration
- Correcting the Color Gradation
- Adjusting Printing Position
- Replenishing and Replacing Consumables
- Consumables
- Specifications
- Information for This Printer
- User Information on Electrical & Electronic Equipment
- EMC Directive
- Note for the Battery and/or Accumulator Symbol (For EU countries only)
- Environmental Advice for Users
- Notes for users in the state of California
- ENERGY STAR Program
- Environmental protection expiration date for use
- Fixed form sentences 11 _ china environmental labeling notice _ LP_Title Sentence 1
- Appendix
Message Cause Solution
" (B) Open Front Cover
and remove the paper."
Open the front cover and remove
the jammed paper from the
internal paper feed path.
For details, see page 420
"Removing Jammed Paper".
" (C) Open Front Cover
and remove the paper."
Open the front cover and remove
any jammed paper from the
output tray.
For details, see page 420
"Removing Jammed Paper".
" (Y) Remove misfeed in
Trays. Opn & cls Frt. Cov."
Open the front cover and remove
any jammed paper.
For details, see page 420
"Removing Jammed Paper".
" (Z) Open Front Cover
and remove the paper."
Open the front cover and remove
any jammed paper from the
paper duplex unit.
For details, see page 420
"Removing Jammed Paper".
" Out of toner" The color toner has run out.
Replace the toner cartridge.
For details, see page 449
"Replacing the Print Cartridge".
" Waste Toner Bottle full" Replace the waste toner bottle. For details, see page 451
"Replacing Other Consumables".
"Cannot
connect=>Comm.Serv.
Check proxy user/
password."
The proxy user name or password
is incorrect.
Check the proxy server settings,
and then change the user name
and/or password if they are
incorrect.
"Cannot connect with DHCP
server.(101/201)"
An IP address cannot be obtained
from the DHCP server.
Contact your network
administrator.
"Cannot print." The printer cannot print the sent
data.
Check that the file you want to
print is a supported file type.
Check the misfeeds and ask your
network administrator for help.
"Change (Tray name) to the
following settings:"
The size of the paper in the tray
does not match the paper size
specified in the printer driver.
Select a tray containing paper
that is the same size as the
specified paper size.
"Check network settings.
(103/203)"
The IP address setting is incorrect. Check the IP address, subnet
mask, and gateway address.
"Classification Code Error" A classification code is not
specified for the print job.
Enter a classification code using
the printer properties and print the
document again.
When Messages Are Displayed
midas-p3_com_operating_instructions_gb_00198757_eng.xml 379
Draft 2016/01/18