User's Manual
Table Of Contents
- 6. Troubleshooting
- 7. Maintenance and Specifications
- General Requirements
- Moving the Printer
- Cleaning the Printer
- Adjusting the Color Registration
- Correcting the Color Gradation
- Adjusting Printing Position
- Replenishing and Replacing Consumables
- Consumables
- Specifications
- Information for This Printer
- User Information on Electrical & Electronic Equipment
- EMC Directive
- Note for the Battery and/or Accumulator Symbol (For EU countries only)
- Environmental Advice for Users
- Notes for users in the state of California
- ENERGY STAR Program
- Environmental protection expiration date for use
- Fixed form sentences 11 _ china environmental labeling notice _ LP_Title Sentence 1
- Appendix
Message Cause Solution
then, under [System], set [Bypass
Print: 64-90 mm] to [Active].
"May have exceeded max
no. of prints in output tray.
Print stopped. Check the
tray."
The output tray is full. Remove paper from the output
tray.
"Parallel I/F Error" The printer's self diagnostic test
failed due to a loopback error.
Replace the IEEE 1284 board
that caused the error.
"Printer Font Error." There are problems with the
printer's font file.
Turn the printer off, and then turn it
on again.
If the problem persists, contact
your sales or service
representative.
"Problem:Wireless board
Please call service."
The printer cannot detect a
wireless LAN interface board.
Check that the wireless LAN
interface board installed correctly.
If the problem persists, contact
your sales or service
representative.
"Replacement Alert Replace
Transfer Belt."
You need to replace the
intermediate transfer unit.
Contact your sales or service
representative to obtain a new
intermediate transfer unit.
"Replacemnt
Requird:IntTrans"
You need to replace the
intermediate transfer unit.
For details, see page 451
"Replacing Other Consumables".
"Replcmnt Requrd: Print
Cart"
The toner has run out, or the
photo conductor unit has reached
the end of its service life.
For details, see xxxxx "Replacing
the Print Cartridge".
"Replacmnt Rqrd:Fusing
Unit"
You need to replace the fusing
unit.
For details, see page 451
"Replacing Other Consumables".
"Replcmnt Rqrd
Soon:IntTrans"
You will need to replace the
intermediate transfer unit soon.
Contact your sales or service
representative to obtain a new
unit.
"Repl Requrd
Soon:FusingUnit"
You will need to replace the
fusing unit soon.
Contact your sales or service
representative to obtain a new
unit.
When Messages Are Displayed
midas-p3_com_operating_instructions_gb_00198757_eng.xml 381
Draft 2016/01/18