User's Manual
Table Of Contents
- 6. Troubleshooting
- 7. Maintenance and Specifications
- General Requirements
- Moving the Printer
- Cleaning the Printer
- Adjusting the Color Registration
- Correcting the Color Gradation
- Adjusting Printing Position
- Replenishing and Replacing Consumables
- Consumables
- Specifications
- Information for This Printer
- User Information on Electrical & Electronic Equipment
- EMC Directive
- Note for the Battery and/or Accumulator Symbol (For EU countries only)
- Environmental Advice for Users
- Notes for users in the state of California
- ENERGY STAR Program
- Environmental protection expiration date for use
- Fixed form sentences 11 _ china environmental labeling notice _ LP_Title Sentence 1
- Appendix
Message Cause Solution
"SD Card
authenticatn.failed"
Authentication from the SD card
failed.
Turn the printer off, and then turn it
on again. If the problem persists,
contact your sales or service
representative.
"Set the Fusing Unit
correctly."
The fusing unit may not be
installed correctly. Turn the printer
off and re-install the fusing unit.
If the message is still displayed
after re-installation, contact your
sales or service representative.
For details, see page 451
"Replacing Other Consumables".
"Set the Intermediate
Transfer Unit correctly."
The intermediate transfer unit may
not be installed correctly. Turn the
printer off and re-install the
intermediate transfer unit.
If the message is still displayed
after re-installation, contact your
sales or service representative.
For details, see page 451
"Replacing Other Consumables".
"Set the Print Cartridge
correctly."
The print cartridge may have not
been installed correctly.
Turn the printer off, and install the
print cartridge again.
"Set Waste Toner Bottle
correctly."
The waste toner bottle may not be
installed correctly. Turn the printer
off and re-install the waste toner
bottle.
If the message is still displayed
after re-installation, contact your
sales or service representative.
For details, see page 451
"Replacing Other Consumables".
"Output Tray is full. Remove
paper."
The output tray is full. Remove the paper.
"Supply order has failed." The automatic supply order failed. The message indicates the printer
tried to order the supplies.
"This NetBIOS name is
already in use.(108/208)"
The NetBIOS name specified for
the printer is already used by
another device on the network.
Contact your network
administrator.
6. Troubleshooting
382 midas-p3_com_operating_instructions_gb_00198757_eng.xml
Draft 2016/01/18