User's Manual
Table Of Contents
- 6. Troubleshooting
- 7. Maintenance and Specifications
- General Requirements
- Moving the Printer
- Cleaning the Printer
- Adjusting the Color Registration
- Correcting the Color Gradation
- Adjusting Printing Position
- Replenishing and Replacing Consumables
- Consumables
- Specifications
- Information for This Printer
- User Information on Electrical & Electronic Equipment
- EMC Directive
- Note for the Battery and/or Accumulator Symbol (For EU countries only)
- Environmental Advice for Users
- Notes for users in the state of California
- ENERGY STAR Program
- Environmental protection expiration date for use
- Fixed form sentences 11 _ china environmental labeling notice _ LP_Title Sentence 1
- Appendix
Message Cause Solution
"The same IPv4 Address
already exists.(102/202)"
The IPv4 address specified for the
printer is already used by another
device on the network.
Contact your network
administrator.
"The selected job has
already been printed or
deleted."
This message might appear if you
print or delete a job from Web
Image Monitor.
Press Exit on the message screen.
"USB has a problem. /
Please call service."
The printer has detected a USB
board failure.
Turn the printer off, and then turn it
on again. If the problem persists,
contact your sales or service
representative.
"Values set for IPv6/
Gateway addresses are
invalid.(110/210)"
The IPv6 address or gateway
address is invalid.
Check the network settings.
"WPA Auth. incomplete.
(211)"
WPA authentication could not be
completed.
Contact your network
administrator.
Message Cause Solution
"Cannot connect with the
wireless card. Turn the main
power switch off, then check
the card."
• The wireless LAN interface
board was not inserted when
the printer was turned on.
• The wireless LAN interface
board was pulled out after
the printer was turned on.
• The settings are not updated
although the unit is detected.
• Turn off the main power
switch, and then confirm the
wireless LAN interface board
is inserted correctly. For
details about installing the
board, contact your service
representative.
• If the message appears
again, contact your service
representative.
"Cannot print because both
the main and designation
(chapter) sheets are set to
the same paper tray. Press
[Job Reset] to cancel the
job."
The tray selected for other pages
is the same as the one for slip
sheets.
Reset the job. Be sure the tray you
select for slip sheets is not
providing paper for other pages.
When Messages Are Displayed
midas-p3_com_operating_instructions_gb_00198757_eng.xml 383
Draft 2016/01/18