User's Manual

Message Cause Solution
"Hardware Problem:
Ethernet"
An error has occurred in the
Ethernet interface.
Turn the main power switch off
and then back on again. If the
message appears again, contact
your service representative.
"Hardware Problem: HDD" An error has occurred in the hard
disk.
• Turn the main power switch
off and then back on again.
If the message appears
again, contact your service
representative.
• The hard disk may have not
been installed properly if
you have installed it yourself.
Check that it is properly
installed For details about
installing the unit, see
page 59 "Installing the Hard
Disk".
"Hardware Problem:
Parallel I/F"
An error has occurred in the IEEE
1284 interface board.
• Turn the main power switch
off and then confirm the IEEE
1284 interface board is
inserted correctly. For details
about installing the board,
see page 63 "Installing the
Interface Units".
• If the message appears
again, contact your service
representative.
"Hardware Problem: USB" An error has occurred in the USB
interface.
Turn the main power switch off
and then back on again. If the
message appears again, contact
your service representative.
"Hardware Problem:
Wireless Card"
(A "wireless LAN interface
board" is referred to as a
"wireless card".)
The wireless LAN interface board
can be accessed, but an error
was detected.
• Turn off the main power
switch, and then confirm the
wireless LAN interface board
is inserted correctly. For
details about installing the
board, see page 63
6. Troubleshooting
384 midas-p3_com_operating_instructions_gb_00198757_eng.xml
Draft 2016/01/18