User's Manual
Table Of Contents
- 6. Troubleshooting
- 7. Maintenance and Specifications
- General Requirements
- Moving the Printer
- Cleaning the Printer
- Adjusting the Color Registration
- Correcting the Color Gradation
- Adjusting Printing Position
- Replenishing and Replacing Consumables
- Consumables
- Specifications
- Information for This Printer
- User Information on Electrical & Electronic Equipment
- EMC Directive
- Note for the Battery and/or Accumulator Symbol (For EU countries only)
- Environmental Advice for Users
- Notes for users in the state of California
- ENERGY STAR Program
- Environmental protection expiration date for use
- Fixed form sentences 11 _ china environmental labeling notice _ LP_Title Sentence 1
- Appendix
Default: [128 KB]
• 128 KB
• 256 KB
I/O Timeout
You can specify how many seconds the printer should wait before ending a print job. If printing
operation is frequently interrupted by data from other ports, you can increase the timeout period.
Default: [15 seconds]
• 10 seconds
• 15 seconds
• 20 seconds
• 25 seconds
• 60 seconds
Network
You can configure the network settings. For details, see page 90 "Configuration".
Machine IPv4 Address
You can specify whether to set the IPv4 address automatically or manually.
Default: [Auto-Obtain (DHCP)]
Auto-Obtain (DHCP)
When DHCP is set to On, the IPv4 address, subnet mask address, and gateway address
cannot be changed. To change them, set DHCP to Off. Contact your administrator for
information about the network configuration.
Specify
• IP Add.
Manually specify the IPv4 address.
Default: 11.22. 33.44
• Subnet M
Manually specify the subnet mask.
Default: 0.0.0.0
• Gateway
Manually specify the gateway address.
Default: 0.0.0.0
IPv6 Stateless Setting
You can specify whether to enable or disable stateless IPv6 address auto configuration.
Default: [Active]
5. Configuring and Managing the Printer
256 midas-p3_com_operating_instructions_gb_00208890_eng.xml
Draft 2016/01/18