User's Manual
Table Of Contents
- 6. Troubleshooting
- 7. Maintenance and Specifications
- General Requirements
- Moving the Printer
- Cleaning the Printer
- Adjusting the Color Registration
- Correcting the Color Gradation
- Adjusting Printing Position
- Replenishing and Replacing Consumables
- Consumables
- Specifications
- Information for This Printer
- User Information on Electrical & Electronic Equipment
- EMC Directive
- Note for the Battery and/or Accumulator Symbol (For EU countries only)
- Environmental Advice for Users
- Notes for users in the state of California
- ENERGY STAR Program
- Environmental protection expiration date for use
- Fixed form sentences 11 _ china environmental labeling notice _ LP_Title Sentence 1
- Appendix
Print the gradation correction sheet, and then check the correction result.
3. Print gradation correction sheet 2.
Adjust the parts of middle colors.
Set the correction value.
Print the gradation correction sheet, and then check the correction result.
4. Save the correction value.
Gradation Correction Sheet
Reading the gradation correction sheet
The printed gradation correction sheet is read as shown below:
While comparing the gradation correction sheet and correction value of each color, K (black), M
(magenta), and C (cyan)/Y (yellow) determine the required gradation correction and configure
the settings using the control panel.
BFL359S
1. K (black) correction value
Adjusts the color printed when only black toner is used. The currently set correction value is printed in
red.
2. M (magenta) correction value
Adjusts the color printed when only magenta toner is used. The currently set correction value is printed in
red.
3. C (cyan)/Y (yellow) correction value
Corrects the colors printed when cyan and yellow are used. For C/Y (cyan/yellow), the correction
value is determined based on a combination of these two colors, although panel settings are configured
for each color.
7. Maintenance and Specifications
442 midas-p3_com_operating_instructions_gb_00198792_eng.xml
Draft 2016/01/18