User's Manual
Table Of Contents
- 6. Troubleshooting
- 7. Maintenance and Specifications
- General Requirements
- Moving the Printer
- Cleaning the Printer
- Adjusting the Color Registration
- Correcting the Color Gradation
- Adjusting Printing Position
- Replenishing and Replacing Consumables
- Consumables
- Specifications
- Information for This Printer
- User Information on Electrical & Electronic Equipment
- EMC Directive
- Note for the Battery and/or Accumulator Symbol (For EU countries only)
- Environmental Advice for Users
- Notes for users in the state of California
- ENERGY STAR Program
- Environmental protection expiration date for use
- Fixed form sentences 11 _ china environmental labeling notice _ LP_Title Sentence 1
- Appendix
Fusing Unit Off Mode Timer
You can specify the period of time the printer waits before entering Fusing Unit Off mode.
The timer is reset if any key on the control panel is pressed or printing is performed.
Default: [10 seconds]
The Fusing Unit Off Mode Timer is reset when:
• A print is performed
• A cover is opened when [Exit Fusing Unit Off Mode] is set to [On Printing]
• Any key on the operating panel is pressed when [Exit Fusing Unit Off Mode] is set to [On
Operating Control Panel]
Weekly Timer
You can set the timer for the printer to turn off and on the main power or to enter and exit Sleep
mode every day or on specified days of the week.
To use Weekly Timer, the date and time of the internal clock must be set using the control panel. For
details, see page 288 "Timer Settings".
When Weekly Timer is set to [Daily] or [Day of the Week], the printer does not turn on even if
[ECO Night Sensor] is set to [Power Off and On] and the time for turning on the main power
specified in [Timer to Turn On] elapses.
Default: [Inactive]
• Daily
• Day of the Week
• Inactive
When [Daily] or [Day of the Week] is selected, you can specify the following:
Weekly Timer Code
To configure this setting, administrator authentication must be enabled. For details, see
Security Guide.
You can set a password (up to eight digits) for Weekly Timer. Once the password is set, the
screen requiring the password is displayed while the printer is turned off or in Sleep mode by
Weekly Timer. Enter the password to turn on the printer or recover the printer from Sleep
mode.
If you set Weekly Timer Code to [Off], you do not need to enter a password to recover the
printer.
Default: [Off]
Weekly Timer Schedule
You can specify when Weekly Timer takes effect (up to six settings).
5. Configuring and Managing the Printer
290 midas-p3_com_operating_instructions_gb_00208911_eng.xml
Draft 2016/01/18