User's Manual
Table Of Contents
- 6. Troubleshooting
- 7. Maintenance and Specifications
- General Requirements
- Moving the Printer
- Cleaning the Printer
- Adjusting the Color Registration
- Correcting the Color Gradation
- Adjusting Printing Position
- Replenishing and Replacing Consumables
- Consumables
- Specifications
- Information for This Printer
- User Information on Electrical & Electronic Equipment
- EMC Directive
- Note for the Battery and/or Accumulator Symbol (For EU countries only)
- Environmental Advice for Users
- Notes for users in the state of California
- ENERGY STAR Program
- Environmental protection expiration date for use
- Fixed form sentences 11 _ china environmental labeling notice _ LP_Title Sentence 1
- Appendix
Default: [Infrastructure Mode]
SSID Setting
You can specify the SSID settings to distinguish the access point in [Infrastructure Mode] or
[802.11 Ad-hoc Mode]. The characters that can be used are ASCII 0x20-0x7e (32 bytes).
Ad-hoc Channel
You can specify the channel to use when [802.11 Ad-hoc Mode] has been selected. Set the
channel that matches the type of the wireless LAN being used.
Default: [11]
• IEEE 802.11b/g Wireless LAN
Frequency range:
2412–2462 MHz (channels 1–11)
• IEEE 802.11a Wireless LAN
Frequency range:
5180–5240 MHz (channels 36, 40, 44, and 48)
• IEEE 802.11n Wireless LAN
Frequency range:
2412–2462 MHz (channels 1–11)
5180–5240 MHz (channels 36, 40, 44, and 48)
Security Method
You can specify whether or not to enable an encryption method and security type when
encryption is enabled.
Default: [Off]
• WEP
Press [WEP (Encryption) Key], and then enter the WEP key using hexadecimal and ASCII
characters.
• WPA2
Press [WPA2 Authent. Method], and then select the authentication method.
If you select WPA2, the encryption method is set to CCMP (AES) and cannot be
changed.
Select one of the following authentication methods:
WPA2-PSK, WPA2
If you select WPA2-PSK, enter a passphrase (from 8 to 63 characters).
• Off
5. Configuring and Managing the Printer
296 midas-p3_com_operating_instructions_gb_00208911_eng.xml
Draft 2016/01/18