User's Manual
Table Of Contents
- TABLE OF CONTENTS
- 1. Getting Started
- Before You Start
- Manuals for This Machine
- Guide to Names and Functions of Components
- Using the Screen on the Control Panel
- Logging in to the Printer
- User Code Authentication Using the Control Panel
- User Code Authentication Using a Printer Driver
- Logging In Using the Control Panel
- Logging Out Using the Control Panel
- Logging In Using a Printer Driver
- Logging In Using Web Image Monitor
- Logging Out Using Web Image Monitor
- User Lockout Function
- Changing the Login Password
- Downloading Utility Software
- 2. Setting Up the Printer
- Printer Set Up Procedure
- Install Location
- Checking the Contents of the Box
- Unpacking
- Installing Options
- Connecting the Power Cord
- Turning On/Off the Power
- Selecting the Display Language
- Connecting the Printer
- Configuration
- Test Printing
- 3. Loading Paper
2. Check the radio wave status.
[Wireless LAN Signal] Check the radio wave status [Exit]
Connecting to the USB Device Server
This section explains how to connect an Ethernet interface cable to the USB device server.
The network interface cable connected to the USB device server must use a ferrite core to prevent RF
interference.
• Be sure to turn off the power switch of the printer before connecting or disconnecting the Ethernet
interface cable.
1. Make a loop at a distance of a few centimeters (1) from each end of the Ethernet interface
cable, and then attach to each loop the ferrite core provided with the USB device server.
1
1
BZU010
2. Setting Up the Printer
88 midas-p3_com_operating_instructions_gb_00198490_eng.xml
Draft 2016/01/18