User's Manual
Table Of Contents
- TABLE OF CONTENTS
- 1. Getting Started
- Before You Start
- Manuals for This Machine
- Guide to Names and Functions of Components
- Using the Screen on the Control Panel
- Logging in to the Printer
- User Code Authentication Using the Control Panel
- User Code Authentication Using a Printer Driver
- Logging In Using the Control Panel
- Logging Out Using the Control Panel
- Logging In Using a Printer Driver
- Logging In Using Web Image Monitor
- Logging Out Using Web Image Monitor
- User Lockout Function
- Changing the Login Password
- Downloading Utility Software
- 2. Setting Up the Printer
- Printer Set Up Procedure
- Install Location
- Checking the Contents of the Box
- Unpacking
- Installing Options
- Connecting the Power Cord
- Turning On/Off the Power
- Selecting the Display Language
- Connecting the Printer
- Configuration
- Test Printing
- 3. Loading Paper
4. Select [Auto-Obtain (DHCP)] Press [OK]
You can check the detected addresses by pressing [IP Add.], [Subnet M], and [Gateway].
1. Press the [User Tools] key, and then display the [Network] screen.
[System Settings] [Interface Settings] [Network]
2. Enable IPv4 protocol, and then specify the IPv4 address.
• [Effective Protocol]
Enable IPv4 protocol.
Press [Active] under "IPv4" [OK]
• [Machine IPv4 Address]
Specify the printer's IPv4 address.
[Auto-Obtain (DHCP)] [OK]
Setting Ethernet Speed
You can set the speed that the printer will use for Ethernet communication. Usually, you should set the
printer to select the Ethernet speed automatically. This setting allows two interfaces to determine the
optimum speed when they are connected.
• A connection cannot be established if the selected Ethernet speed does not match your network's
transmission speed.
• To reduce the power consumption of network devices, the default Ethernet speed of the printer
does not exceed 100BASE-TX (100 Mbps). To communicate using a higher speed, enable
1000BASE-T (1Gbps) communication by selecting the following from [Ethernet Speed]:
• [Auto Select: Enable 1Gbps] (for SP C340DN)
• [AutoSelct:Enable 1Gbps] (for SP C342DN)
Press the [Menu] key, and then select the setting items using the [ ] or [ ] key.
1. Select [Host Interface] Press [OK]
2. Select [Network] Press [OK]
3. Select [Ethernet Speed] Press [OK]
4. Select the Ethernet speed Press [OK]
2. Setting Up the Printer
92 midas-p3_com_operating_instructions_gb_00198499_eng.xml
Draft 2016/01/18