Operation Manual Digital Camera RDC-5000

112
Using the Remote Control
The DR-3 remote control unit (optional) makes it possible to record and play back
images from a remote location.
Important
Note
• The remote control receiver is located on the right side of the lens.
Operate the remote control unit by pointing it at the remote control
receiver.
Note
• For instructions on replacing the batteries and maintaining the remote
control unit, refer to the accompanying manual.
• Some procedures differ when performed on the remote control unit and
on the camera itself. Follow the instructions below to use the remote
control unit.
Shooting
The remote control unit can be used to operate the camera. It is particularly
convenient when the camera is set up at a remote location or is in a fixed position.
q Set the mode dial to [ ] and press the
CARD/IN button to select a recording
destination.
w Decide the composition of the picture
and press the RELEASE button on the
remote control unit.
The self-timer LED will light and recording will
start about 2 seconds later.
Note
• Use the zoom buttons to vary the size
of the subject. The
button
magnifies the subject (telephoto), while
the
button decreases the size of
the subject (wide angle).
RELEASE
ERASE
FWD
PROGR A M
EV
MULTI
RE V
ENTER