Manualshelf

User's Manual

ManualsBrandsRicoh ManualsPrintersRicoh Ricoh Printer L4130
61626364656667686970
2-23
1
2
Basic Operations
4
5
6
Set the media feeding
Correct the feeding rate of media.
If the correction value is not appropriate, stripes may appear on the printed image, thus resulting in a poor
printing.
Setting Feed Correction
A pattern for media correction is printed and a media-feeding rate is corrected.
1
Set a media. ( P.2-5)
2
Press the key in LOCAL.
3
Press the key.
4
Press the key to print a correction pattern.
5
Check the correction pattern and enter a correction
value.
Enter a correction value in "+": The boundary between the two bands is widened.
Enter a correction value in "-": The boundary between the two bands is narrowed.
• When you have changed the media type, check the pattern and perform adjustment depending on the
status.
• When you have changed the temperature of the heaters, make sure that the [CONSTANT] lamp lights
up and that the preset temperature is reached, and then start the correction.
• When using a roll medium, rewind the medium by hand before printing so that it is not loose. When
the roll medium has not been rewound tightly, it may cause image quality to deteriorate.
• When printing with a take-up device, set the media first and then perform media correction.
• Two bands are printed in the correction pattern.
• Make adjustment so that an even color density is obtained in the boundary between the two bands.
• If the correction pattern that has been printed on a media such as transparent film is difficult to
discern, feed the media forward so that the printed area is out of the drying heater, place a sheet of
paper on the back of the media, and then rewind the media.
• When making adjustment to the media-feeding rate, use of a magnifying glass is recommended.
FEED COMP .
<ENT>
FEED COMP .
PR I NT [ ENT ]
** PRINTING **
PLEASE WA I T
FEED COMP .
=0