User's Manual

2-24
Set the media feeding
6
Press the key.
• Print a correction pattern again and check it.
• When media correction is needed, perform the operation in Step 5
to make correction.
7
Press the key several times to end the setting.
Performing the station maintenance without key
You can select “FEED COMP.” by using the key in the Local without pressing the key.
Correcting Media-feeding during Printing
A media-feeding rate can be corrected even in the remote mode or when image data is printed.
1
Press the key in the Remote.
2
Press to enter a corrected feeding rate.
• Corrected feeding rate: -255 to 255
• The value entered here is reflected in the corrected feeding rate soon.
3
Press the key.
• The changed value is registered.
• When you press the key instead of the key, the
value entered here will be invalid.
Press the
key in Local.
Press to
select [SETUP].
Press the key twice.
• It becomes the same condition as the
key is pressed from Local.
FEED COMP .
PR I NT [ ENT ]
*REMOTE*
**.**mm
FEED COMP .
0
X
0
Current [FEED COMP.] value
*REMOTE*
**.**mm