User's Manual

3-2
List of Functions
This section describes the overview of each function to be set and set values that can be registered in user
types.
• About default “HOST” function
You can operate this by the setting value specified in RIP software.
When you set to other than “HOST”, it operates by that setting value, not by the instruction from RIP
software.
Depending on RIP software, there are some functions that cannot be instructed by software. In such a
case, it operates by the setting value of “When no instruction from RIP exists”.
• For the specifying method with the RIP software, refer to the operation manual of the RIP software.
Function name Set value Default
When no instruction
from RIP exists
*1
*1. This is the setting value to be used for printing when setting value is not specified at the RIP software (host) side, or, you give priority
to the setting value at the machine side, even if you set “Host” to the type registration of this machine.
Outline
FEED COMP. ( P.2-23) -9999 ~ 0 ~ 9999 0
Used to print a pattern for
correcting a media-feeding rate
and correct it.
DROP. POS CORRECT -40.0 ~ 0 ~ 40.0 0
Used to adjust the dot position in
go and return printing.
HEATER
( P.2-17)
Pre-Heater
OFF/ 20 ~ 70°C
(OFF/ 68 ~ 122°F)
OFF
Sets heater conditions.Print Heater
OFF/ 20 ~ 70°C
(OFF/ 68 ~ 122°F)
OFF
Post Heater
OFF/ 20 ~ 70°C
(OFF/ 68 ~ 122°F)
OFF
FAN HEATER (P.2-
18)
OFF/
POST+0 ~ 20°C
*2
*2. The setting value range shall be within the POST heater setting value +20 ℃ .
OFF
Sets drying heater conditions.
LOGICAL SEEK
(P.3-3) HOST / ON / OFF HOST
OFF
Sets the scan movable area
during printing.
INK LAYERS ( P.3-9) HOST /1 ~ 9 HOST
1
Sets the number of layers in
which ink is to be applied.
DRYING
TIME
(P.3-4)
SCAN HOST /0.0 ~ 9.9 sec HOST
0.0 sec
Sets the time to wait for ink
drying.
MARGIN
(P.3-5)
LEFT
HOST / -10 ~ 85mm
(1mm unit)
HOST
0 mm
Sets a non-printing area along
the right and left edges of the
media.
RIGHT
HOST / -10 ~ 85mm
(1mm unit)
HOST
0 mm
VACUUM ( P.3-9)
HOST / STANDARD /
STRONG
HOST
STANDARD
Sets the absorbability of the
media.
FEED SPEED ( P.3-9) HOST / 10 ~ 200% HOST
100%
Changes the media feeding
speed in printing.
*3
*3. When you set this to “100%” or more, required time for completion of printing will be shortened. However, enough drying time cannot
be ensured and it may affect the image quality.
MAPS
(P.3-6)
OFF / ON OFF
Perform setting to reduce stripes
between passes.
PRINT SPEED
ADJUST
-50 ~ +50% 0%
AUTO
CLEANING
(P.3-7)
INTERVAL
OFF / 1 ~ 1000 page OFF
Sets the automatic cleaning
operation of the head at the start
of printing.
TYPE
SOFT / NORMAL /
HARD
SOFT
INTERVAL
WIPING
(P.3-8)
TYPE1
Lv1 ~ Lv6,
MANUAL(90~600sec)
Lv4
Set wiping interval performed
during printing.
TYPE2
Lv1 ~ Lv6,
MANUAL(10~90min)
Lv4