User's Manual

3-5
1
1
3
Convenient use
5
6
Setting Margins
Set a non-printing area along the right and left edges of the media.
The offset value against the standard margin 15mm is set hereupon.
1
Press the key in LOCAL.
2
Press the key.
3
Press to select [MARGIN].
4
Press the key.
5
Press to set the left margins.
Set Value :HOST or -10 to 85mm (in 1mm increment)
6
Press the key.
7
Press to set the right margins.
Set Value :HOST or -10 to 85mm (in 1mm increment)
8
Press the key.
9
Press the key several times to end the setting.
• When you give priority to the setting at the RIP software side, make the setting value “Host”.
• You cannot specify the margins at the attached RIP software (RICOH Software RIP). When you use
the RICOH Software RIP, if you set this machine to “Host”, printing will be performed in “Margins for
right and left off set value= 0 mm” status.
• Pay attention to that printing may start on the media press if a right and left margin is set to 5
mm or less when the media press is used in printing.
FUNCT I ON
SETUP [ ENT ]
SETUP
FEED COMP . [ ENT ]
SETUP
MARG I N [ ENT ]
LEFT
=HOST
LEFT
=0mm
RIGHT
=HOST
RIGHT
=0mm
SETUP
MARG I N [ ENT ]