User's Manual

19
Preparations
Loading dry-cell batteries
into the remote control
1
Remove the battery cover.
2
Insert the dry-cell batteries.
Be sure to align the plus and minus
ends of the batteries properly.
Two batteries (LR03, SIZE AAA) are used.
3
Replace the battery cover.
 Operating the remote
control
Point toward the projector’s infrared
remote sensor, and press any button
on the remote control.
Operating the projector from the front
Approx.15°
Appr
o
x
.5
m
Note:
When operating the remote control
from behind the projector, the infrared
signal is reflected on the projecting
surface. The operating range therefore
may decrease depending on the
shape and material of the projecting
surface.

•
Dry-cell batteries
Before using the batteries, be sure to observe the Safety Precautions described in
previous pages.
Remove batteries from remote control when not using for extended periods.
If the remote control stops working, or if its range decreases, replace all the batteries
with new ones. (2 batteries (LR03 SIZE AAA))
Keep the batteries away from the reach of children.
Batteries are choking hazards and can be very dangerous if swallowed. If the batteries
are swallowed, seek medical assistance immediately.
The remote control
The remote control may fail to operate if the infrared remote sensor is exposed to bright
sunlight or fluorescent lighting.
Do not drop or bang.
Do not leave in hot or humid locations.
Do not allow it to get wet or place it on top of wet objects.
Do not take it apart.
In rare cases, ambient conditions could impede the operation of the remote control. If
this happens, point the remote control at the main unit again, and repeat the operation.
•
•
•
•
•
•
•
•
•
•
Preparing and using the remote control