User's Manual

43
Operations
[Voice guide]
Even when you set the [Voice guide] to [Off], it still informs you of the abnormal
conditions.
[Power on]
If [Power on] is set to [Auto] and there is a power outage, the projector will come on
once power is restored.
[Network standby]
When [Network standby] is set to [On], the network is switched to the standby state as
the projector enters standby. While the network is in standby, the projector can be powered
on using the remote control function of the Network Utility. When [Network standby] is
set to [Off], the projector cannot be powered on with the remote control function of the
Network Utility.
[Lamp power]
When [Lamp power] is set to [Low], the screen becomes a little darker, but the cooling
fan noise gets quieter.
Default setting 2 menu
Item
Description
Projection
mode
Sets projection mode in accordance with Placement Style.
p.21
(Standard)
(Rear) (Ceiling) (Rear ceiling)
Fan mode Sets the cooling fan speed. Standard High
Remote control When 2 projectors are used and controlled by the remote control respectively,
this menu sets the code for the projector and the remote control.
[ or : Enter setting] [
: Select from 1, 2
] [ : Confirm]
[
:Select OK to end
]
Press [Cancel] to return.
Key lock Lock the control panel buttons.
[ or : Enter setting] [
: Select On/Off
] [ : Confirm]
[
:Select OK to end
]
Press [Cancel] to return.
Closed Caption Closed Caption settings.
Press or and switch with and .
Off/ CC1/ CC2/CC3/CC4/T1/T2/T3/T4
Reset all
Press . (The password and user logo are not reset.)
Resets all adjustments and settings to their factory settings.
Yes No
Password
Password setting
p.34
Press . Password registration/Password setting
Detailed description
[Fan mode]
Setting [Fan mode] to [High] increases the cooling fan speed. (The cooling fan noise
increases.) Set this option to use the projector at high altitude (over 1,500 meters
above sea level).
Do not set Fan mode to [High] when using the projector at a lower altitude.
•