User's Manual

45
Operations
Displaying Information (Status display)
This displays information about the input signal, lamp use time, etc.
“Yes”: displayed, “No”: not displayed
Item Description Computer Y/PB/PR HDMI Video S-video Network USB memory
Input Input source name Yes Yes Yes Yes Yes Yes Yes
Mode name RGB or HDMI signal mode
[Note 1]
Yes No Yes No No No No
Resolution Resolution (in dots) Yes No Yes No No No No
Frequency Sync frequency Yes No Yes No No No No
Sync Sync signal polarity
[Note 2]
Yes No No No No No No
Signal format Y/PB/PR signal format No Yes No No No No No
Video mode Color method of video signal No No No Yes Yes No No
Lamp time Time of lamp use
[Note 3]
Yes Yes Yes Yes Yes Yes Yes
Lamp reset
count
The count for lamp
replacement
Yes Yes Yes Yes Yes Yes Yes
Total time The total time that this
projector is used.
Yes Yes Yes Yes Yes Yes Yes
Version Firmware version
[Note 4]
Yes Yes Yes Yes Yes Yes Yes
Notes
1: The mode of supported RGB signals
p. 100
and HDMI signals
p. 101
are shown.
2: Sync signal polarity shown as P (positive) or N (negative) for [H/V].
3: Displays [
Lamp time] as an estimated measure of when the lamp should be replaced.
(Cannot be used as a counter of guaranteed lamp time.)
4: [
Version] shows the version of the projector’s internal control program. This version
will be requested for customer service purposes.
Note
The displayed information will not be refreshed if the status changes. To refresh the
information, dismiss the display, then display it again.

•